WAT2004 Display Image

Stuart Aquatron Water Still A4000D

Code: WAT2004 92

Three models are available giving outputs of 4 or 8 litres/hour single or 4 litres/hour double distilled water. The high quality borosilicate glassware coupled with silica sheathed heaters gives py...

read more

ADD
£2,657.00 EACH Offer Price 3,796.00(30%)

3 Year Warranty

Three models are available giving outputs of 4 or 8 litres/hour single or 4 litres/hour double distilled water. The high quality borosilicate glassware coupled with silica sheathed heaters gives pyrogen free distillate of the highest purity from virtually any raw water supply.

The unique condenser design ensures that the droplets of distilled water remain in contact with the cooling coil for the longest possible time ensuring maximum energy transfer. This produces cold distilled water ready for immediate use and pre-heats the boiler feed to increase efficiency.

All glass construction allows rapid descaling using strong mineral acids. A built in "clean" function and integral acid addition funnel make the cleaning operation simple and safe with no need to dismantle any of the glassware. A large bore stopcock with PTFE key is fitted for easy draining of chemicals after cleaning. 

A flow sensing device will detect any reduction in the flow of cooling water to below the required level and will turn off the still before it can overheat. Sensing the flow of cooling water rather than its pressure is safer and allows the still to run normally on low pressure supplies down to 3psi (20kPa). As a fail-safe device there is an over-temperature thermostat mounted in the boiling chamber.

The Aquatron is very easy and safe to assemble and maintain. Both the acrylic safety screen and the cabinet lid are removable giving unrivalled access to the glassware components. Screwthreads are incorporated on all water connections so hoses can be fitted and removed easily and safely without risk of breakage. Every Aquatron® water still is supplied with a reservoir level control.

The control is a simple and effective system which can be fitted to virtually any type of reservoir vessel. It will turn the still off when the reservoir is full and restart it when the level in the reservoir drops as distilled water is removed for use making it fully automatic. water purification

  • Automatic water stills
  • Improved safety to BSI and IEC1010 standards
  • Easy to clean
  • High quality water output
  • Simple installation and servicing
  • Operates from virtually any water source
  • Pyrex double pitch coil condenser gives low temp distillate(25-35°C)
  • Two safety cut-outs protect in the event of failure of feed water
  • Long life heating element sheathed in silica glass
  • For 220/240 volt, single phase supply. (13A on WAT2000, 30A on WAT2002 and WAT2004)
A4000
A8000
A4000D
Output, L/Hr
4, single
8, single
4, double
pH
5.0 - 6.5
5.0 – 6.5
5.0 – 6.5
Conductivity, uScm-1
1.0 - 2.0
1.0 - 2.0
1.0 - 1.5
Resistivity, mOhm-cm
0.5 - 1.0
0.5 - 1.0
0.7 - 1.0
Temperature, celcius
25 - 35
25 - 35
25 - 35
Pyrogen Content*
Pyrogen Free
Pyrogen Free
Pyrogen Free
Water Supply
1 L/min 3-100psi
2 L/min 3-100psi
2 L/min 3-100psi
(20-700kPa)
(20-700kPa)
(20-700kPa)
Electrical Supply
220/240V, 50-60Hz,
220/240V, 50-60Hz,
220/240V, 50-60Hz,
Single Phase
Single Phase
Single Phase
Max Power, kW
3
6
6
Size, mm (WxDxH)
550 x 240 x 410
550 x 240 x 410
550 x 410 x 410
IP Rating
21
21
21
*Care required to produce pyrogen free water, output should be tested before use
Code
Description
Unit Size
List Price
Qty
WAT2000
Stuart Aquatron Water Still A4000
Save £724.00 (30%) was £2,413.00

EACH
£1,689.00
ADD
WAT2002
Stuart Aquatron Water Still A8000
Save £1,139.00 (30%) was £3,796.00

EACH
£2,657.00
ADD
Code
Description
Unit Size
List Price
Qty
WAT2010
Stuart 20L Assembly Reservoir Wr20
Save £150.00 (30%) was £500.00

EACH
£350.00
ADD
WAT2012
Stuart Stand Reservoir for WAT2010
Save £112.00 (30%) was £373.00

EACH
£261.00
ADD
W21130
EACH
£143.00
ADD